Industry news

What are the steps for cleaning a water well drilling rig?

The following are the general steps for cleaning a water well drilling rig:

Step 1: Shutdown Preparation

Stop the operation of the water well drilling rig and turn off the power or power source to ensure that the equipment is in a safe condition.

Step 2: Surface cleaning

Use brooms, rags and other tools to first remove obvious dust, dirt, etc. from the outside surface of the equipment.

Step 3: Remove removable parts

According to the actual situation, some removable parts such as drill rods, drill bits, etc. are carefully disassembled for individual cleaning.

Step 4: Selection of cleaning solution

According to the material of the equipment and the degree of pollution to choose the appropriate cleaning fluid, such as diesel fuel, special cleaning agent.

Step 5: Parts cleaning

Use the cleaning fluid to carefully clean the drill pipe, drill bit and other parts to remove the adherents.

Step 6: Equipment body cleaning

Wipe or rinse the main body of the water well drilling rig with a suitable tool dipped in the cleaning solution, taking care to avoid water entering the electrical and other critical parts.

Step 7: Rinsing

Rinse the cleaned areas with water to remove any residual cleaning solution.

Step 8: Drying

Use a clean rag or compressed air to dry the surface and parts of the unit to prevent rust and other problems.

Step 9: Installation reset

Reinstall cleaned and dried parts back into place.

Step 10: Inspection and Maintenance

Carry out a comprehensive inspection of the cleaned water well drilling rig to ensure that all parts are normal, and carry out simple maintenance if necessary.

CONTACT US

Contact: Mr. Jackson Chen

Phone: +86 18574606855

E-mail: md@guangzhouintl.com

Add: Shanhuxi Road Chuangfacheng Plaza Yongzhou City Hunan Province China, Yongzhou, Hunan, China