Hydraulic Valve and Its Function of Crawler Drilling Machine

Do you know the hydraulic valve and its function of a tracked drilling machine? What is the function of this component?
Hydraulic valve is an automated component operated by pressure oil, which is controlled by the pressure oil of the pressure distribution valve. It is usually used in combination with electromagnetic pressure distribution valves and can be used for remote control of the on/off of oil, gas, and water pipeline systems in hydro power stations. It is also widely used in hydraulic pipe pullers and crawler drills. Commonly used for clamping, control, lubrication and other oil circuits. There are two types: direct acting type and pilot type, with pilot type being more commonly used.
Hydraulic valves have two main functions: flow control and pressure control

Hydraulic Valve and Its Function of Crawler Drilling Machine
Hydraulic Valve and Its Function of Crawler Drilling Machine

1. Pressure control: Divided by purpose into relief valves, pressure reducing valves, and sequence valves.
⑴ Pressure reducing valve:

It can control the branch circuit to obtain a stable pressure lower than the main circuit oil pressure. Pressure reducing valves can be divided into constant pressure reducing valves, differential pressure reducing valves, and proportional pressure reducing valves according to the pressure function they control.
⑵ Overflow valve: It can control the hydraulic system to maintain a constant state when reaching the set pressure. The overflow valve used for overload protection is called a safety valve. When the system malfunctions and the pressure rises to a limit that may cause damage, the valve port will open and overflow to ensure the safety of the system.
⑶ Sequential valve: It can make one actuator act and then make other actuators act in sequence. The pressure generated by the oil pump first pushes the hydraulic cylinder to move, and at the same time, it acts on the area through the inlet of the sequential valve. When the hydraulic cylinder is fully moved, the pressure increases, and the upward thrust acting on the area is greater than the set value of the spring. The valve core rises to connect the inlet and outlet ports, causing hydraulic cylinder 2 to move.

2. Flow control:

By adjusting the throttle area between the valve core and valve body and the local resistance it generates, the flow rate is regulated to control the movement speed of the actuator. Flow control valves are divided into 5 types according to their purposes.
⑴ Flow divider and collector valve: It has both the functions of a flow divider valve and a collector valve.
⑵ Throttle valve: After adjusting the throttle area, it can keep the movement speed of the actuator with little change in load pressure and low requirements for motion uniformity basically stable.
⑶ Collecting valve: Its function is opposite to that of a diversion valve, allowing the flow into the collecting valve to be distributed proportionally.
⑷ Speed control valve: It can maintain the inlet and outlet pressure difference of the throttle valve at a constant value when the load pressure changes. In this way, after adjusting the throttle area, regardless of changes in load pressure, the speed control valve can maintain a constant flow rate through the throttle valve, thereby stabilizing the movement speed of the actuator.
⑸ Flow divider valve: Regardless of the size of the load, an equal amount flow divider valve or synchronous valve is used to ensure that two actuator components of the same oil source receive equal flow; The proportional diversion valve is used to distribute flow proportionally.

Scroll to Top